B-band AST Instalační manuál

1A2 INSTALLATION MANUAL B-BAND A2 END PIN PREAMP EQUIPPED WITH HZZLESS™ CIRCUIT.USE WITH B-BAND UST AND AST TRANSDUCERS, AG-MIC, MAGNETIC PICKUPUSE WI

1011Check the bottoms of both the saddle slot and saddle. They should be flat and straight. If all things mentioned above are corre

101114. EU / DECLARATION OF CONFORMITYThis B-Band product has been designed, manu-factured and tested to comply with the require-ments of EMC dir

12International:B-Band LtdKonttisentie 8FI-40800 VAAJAKOSKIFINLANDTel: +358 14 332 9050Fax: +358 14 332 9001Email: [email protected]: www.b-ban

1. SAFETY AND PRODUCT CAUTIONSAlthough B-Band products could be easy to install by follow-ing these instructions carefully and checking the B-Band web

B-BAND LTD, B-BAND, INC. AND B-BAND GMBH WILL NOT BE RESPONSIBLE FOR ANY DAMAGES, PERSONAL INJURIES OR LIABILITIES RESULTING FROM INSTALLATIO

453. OVERVIEW OF A2 PREAMP All B-Band A-series preamps are designed to give optimum performance with B-Band UST and AST transducers. The main

45• Wood or metal drill bit, 3 mm (.12”)• Screwdriver, Posidriv #1• Endpin reamer, 12 mm (.47”) or wood drill bit, 12 mm (.47”)• Allen wrench, 2 mm (.

67strings on the bass strings side at the area between the bridge and soundhole. Sometimes there is also a flat brace running pa-rallel under the bridg

677. CONNECTING THE PICKUPS AND WIRING TO THE PREAMP7.1 Open the preamp and see the picture for connections. Connect the pickup(s), AG-MIC, and batter

89of the end of the jack. Install the strap attachment. Be careful not to over-tighten it…it just needs to be snug.Connect a fresh 9-volt battery to t

89good test is to shake the guitar when plugged into amplifier. If anyt-hing is loose or if the pickup’s leads are touching something you will hear i