B-band AST Instalační manuál stáhnout pdf (Strana 9)

For AST remove the adhesive protective layer from the AST.

Then stick it ﬁrmly by holding and pressing with ﬁngers for a

short while. If necessary, you can remove the AST shortly after

attaching, but be careful when doing this. Carefully lift under

the edge of the AST, with your ﬁngernail, and work it off slowly.

Don’t attempt to lift the AST off by pulling on the transducer

lead. Peel the adhesive off the wood, rather than peeling the

pickup off the adhesive. At installation this can be removed and

reattached two or three times.

Note! After 24 hours the adhesive will dry and it will be hard to

remove. Removal after this time may damage the pickup.

Now install the remote control. The preferred placement is at

the low E string side at the inside of the soundhole. It should be

positioned so that the wheels of the volume and mix control stick

out from the edge of the soundhole. The remote control panel

should ﬁt on a ﬂat surface. Clean the surface with a slightly moist

cloth and let dry before installing. Remove the tape cover at the

control panel and stick it.

Test the system before putting on the strings. To do this, plug into

an ampliﬁer and then tap lightly on the top of the guitar to make

sure that you can hear the transducer when you tap. Another

good test is to shake the guitar when plugged into ampliﬁer.

If anything is loose or if the transducer’s leads are touching

something you will hear it. This should not happen.

Install the strings and test the system. Now play, keep it real

and enjoy!

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

B-band AST Instalační manuál Strana 9